How to reset oil change on chrysler town and country

Last Updated on November 21, 2020 by Christ

2008-2016 Chrysler Town & Country Oil Change Light Reset Guide – Chrysler Town and Country is a minivan manufactured by Daimler Chrysler. Town and Country were introduced in 1990, while similar Dodge Caravan and Plymouth Voyager have been in production since 1984.

The cars were among the first luxury minivans ever produced. Since their introduction, the Chrysler minivan family (Dodge Caravan and Plymouth Voyager) have been the best-selling minivans in the U.S. market.

2008-2016 Chrysler Town & Country Oil Change Light Reset Guide

Time needed: 7 minutes.

When you exceed the next scheduled oil change interval, the Oil Change Required light will display in the screen. The fastest way to reset the oil light on the Chrysler Town & Country is by pressing the gas pedal. Here’s how to get started:

1. Place the ignition to the RUN position without starting the engine

   If your vehicle has the keyless starting system, press the ENGINE START/STOP button twice without pressing the brake pedal

2. Fully depress the GAS pedal, three times within 10 seconds

   Don’t rush, make sure you press it fully

3. Turn off the ignition

   Press the ENGINE START/STOP button once

4. Verify the indicator has been reset by starting the engine

   Done!

These instructions are based on the Chrysler Town & Country owner’s manual. This procedure should apply to the fifth generation of the Chrysler Town & Country (2008 2009 2010 2011 2012 2013 2014 2015 2016 model years). Hopefully, the article 2008-2016 Chrysler Town & Country Oil Change Light Reset Guide can solve your problem. Good Luck!

Reset oil service light Chrysler Town and Country. From years: 2008, 2009, 2010, 2011.

How do you reset oil service light Chrysler Town and Country. From years: 2008, 2009, 2010, 2011.

1. How to reset oil servie light when message Change oil engine appears on display.
2. Turn the ignition to run, one position before starting engine.
3. Fully depress the accelerator pedal slowly three times within 10 seconds. Picture below.
4. 
   .
5. Turn the ignition off and then start the engine to verify the indicator has been reset.

Click here to see where is located and how to replace Chrysler Town and Country cabin air filter.

That it is the full procedure how to reset oil service light Chrysler Town and Country. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Chrysler cars. Or any error which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders when by yourself.

 This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.

Click hear to see full procedure how do you reset the oil light indicator. How to reset the maintenance light and how do you reset service light for all Chrysler vehicles.

The Oil Change Light Reset Chrysler Town and Country 2016 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due.

Below is the Oil Change Light Reset procedure for the Chrysler Town and Country 2013 2014 2015 . Follow the steps below to reset the oil life monitor after each oil change.

Oil Change Light Reset Chrysler Town and Country 2016 Procedure

1. Turn the ignition to the “RUN” position.
2. Immediately press and release the accelerator pedal 3 times within 10 seconds.
3. Turn the ignition off.

Oil Viscosity and Capacity

The 3.6 liter engine holds approximately 5.9 quarts (5.6 liters) of 5W-20 oil when the engine oil and filter are changed.

Not Working?

If the oil change light reset procedure is not working to reset your oil life monitor, make sure you are following each of the steps exactly and in the order displayed in the Oil Change Light Reset Chrysler Town and Country 2016 procedure above. If this is not the oil life monitor reset procedure for your vehicle, restart your oil light reset procedure search HERE

Oil Life Monitor Reset Procedure Frequently Asked Questions

If you are still having trouble with visit the Oil Life Monitor Reset Procedure Frequently Asked Questions (FAQ) page for more information.

Notice

Due to the wide range of vehicles makes and models, this is general information and should not be taken as specific to any vehicle. Please consult the vehicle manufacturer for the correct specifications and repair procedures for your vehicle. This information is meant to be used as a guideline only.