On your 2002 ford explorer v6 there is no way to check the transmission fluid, these are sealed transmissions that do not have a dipstick. Likewise, how do you check the transmission fluid on a Ford Explorer? In order to check the transmission fluid on a ford explorer, you must remove the cap and dipstick located at the front of the engine bay, while the engine is running, and then reinsert and remove the dipstick to measure
fluid level and viscosity. Correspondingly, does a 2002 Ford Explorer take transmission fluid? The 2002 Ford Explorer uses 11 quarts of transmission to completely fill it when it is changed. Ford recommends that You use a Mercon V transmission fluid whenever You need to change the oil in it. Also, where do you add transmission fluid on a 2002 Ford Explorer?
Also the question is, how do you check transmission fluid without dipstick?
Contents
- How do I check my transmission fluid in my 2003 Ford Explorer?
- What are the symptoms of low transmission fluid?
- Why is there no transmission dipstick?
- What happens if there is not enough transmission fluid?
- What kind of transmission fluid goes into a 2002 Ford Explorer?
- What kind of transmission fluid goes in a 2002 Ford Explorer?
- How many quarts does a 2002 Ford Explorer take?
- How do you add fluid to a sealed transmission?
- Where is the dipstick for transmission fluid?
- How do you check the transmission fluid?
How do I check my transmission fluid in my 2003 Ford Explorer?
To check the transmission fluid on a 2003 ford explorer take these steps: open the hood of the car. Locate transmission fluid dipstick. Pull out and wipe off. Dip the stick back in and check fluid line compared to level labels.
What are the symptoms of low transmission fluid?
- Warning light.
- Transmission overheating.
- Difficulty in shifting gears.
- Transmission fluid leakage.
- Generation of unusual sounds.
- Transmission slipping problems.
Why is there no transmission dipstick?
Automatic transmissions which use World Standard (WS) fluid are sealed and do not consume fluid. This eliminates the need for periodic fluid checking using a dipstick. The transmission fluid does not need to be replaced unless an inspection shows it has become necessary.
What happens if there is not enough transmission fluid?
Without the proper amount of fluid, friction will occur. If this friction occurs, these parts will get too hot. Low levels of transmission fluid will cause overheating because there won’t be enough to go through all of the working parts in the transmission. This will lead to a completely damaged transmission.
What kind of transmission fluid goes into a 2002 Ford Explorer?
FRAM Transmission Fluid – Mercon V Automatic Transmission Fluid 1 Quart (Part No. F450) FRAM Mercon® V ATF is for use in Ford vehicle transmissions and transaxles.
What kind of transmission fluid goes in a 2002 Ford Explorer?
Mobil 1 Synthetic Transmission Fluid Dexron, Mercon 1 Quart.
How many quarts does a 2002 Ford Explorer take?
Capacity: 6 quarts (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.
How do you add fluid to a sealed transmission?
Where is the dipstick for transmission fluid?
First, locate the transmission dipstick, which can be found under the hood, in the engine compartment. Make sure you are locating the transmission dipstick and not the engine-oil dipstick; the transmission dipstick is usually further back in the engine bay, toward the firewall (the bulkhead at the front of the cabin).
How do you check the transmission fluid?
- Pull out the dipstick. With the engine on and the gearshift in Neutral or Park and the parking brake on, let your engine run.
- Check the fluid.
- Wipe the dipstick with a clean, lint-free rag; then reinsert it and pull it out again.